Enter Operational Parameter Values (Step 6 of 6)

[About Historical Data] [To Manage Serialized Configuration] [To Perform Maintenance Engineering]

Usage

Use this step of the assistant to register operational parameter values at the time the modification is completed. Click Get Defaults to view the default values for the existing operational parameters.

The operational parameter for which measurements are completed, the accumulated value after the last overhaul and the accumulated total value for the serial part is displayed in the table. The Triggered Execution check box needs to be selected for the operational parameter which triggered this particular action. The triggering operational parameter and its values are stored in the modification history. When you select the triggering operational parameter a warning message will appear if;

• the modification is not purely calendar based and the selected triggering operational parameter is not defined for the modification.
• the modification is purely calendar based and the triggering operational parameter is different to the primary operational parameter.
• executions (inspections) are not defined for the modification.

 When you click Finish the following will occur:

• The modification will be registered as Complied With or Not Complied With (depending on the new execution type that has been selected) in the modification history for the selected serial.
• If operational parameters are given, the values will be connected to the modification history. 

Activity Diagrams

Enter Historical Life Data for Used Serials
Resolve Structure Mismatches, variant MRO

Activities

Enter Complied/Decomplied Modifications