Recalculate Post Maintenance Tasks

Explanation

This activity is used to recalculate the due date for post maintenance check (PMC) tasks.

Prerequisites

• A modification or a fault must exist and post maintenance checks set up for it. For more information, refer to the activities Define Post Maintenance Checks on Modification and Enable Post Maintenance Check For Fault.
• The modification or fault must have been completed and the serial must not have reached the limit that triggers the post maintenance check.
• Post maintenance tasks that are in a planning state (i.e., in the Planned in Scope, Incomplete or Under Preparation status) must be connected to a maintenance order that is not yet released.

System Effects

• The due date of the PMC task can be modified.
• A pending task is created if the due date is within the forewarning limit.
• The recalculation for post maintenance tasks will handle tasks that are included on maintenance orders not yet released.

Window

Modification Details
Post Maintenance Checks
Serial Operational Information

Related Window Descriptions

Modification Details/Post Maint
Post Maintenance Checks
Serial Operational Information/Post Maint

Procedure

Use the following procedure to recalculate the due date for a PMC task on a modification:

1. Open the Modification Details window and query (F3) for the necessary modification and part revision. Note that this activity can also be performed using the Post Maintenance Checks window.
2. Click the Post Maint tab.
3. Select the row containing the serial you want, right-click and then click Recalculate.

Use the following procedure to recalculate the due date for PMC tasks on a serial fault.

1. Open the Serial Operational Information window and query (F3) for the necessary serial.
2. Click the Post Maint tab.
3. Select the row containing the fault number you want, right-click and then click Recalculate.